Thread: ADR 3/03 seats
View Single Post
  #167 (permalink)  
Old 06-04-2013, 03:16 PM
justcobra justcobra is offline
CC Member
Visit my Photo Gallery

 
Join Date: Jun 2012
Location: KILMORE, Vic
Cobra Make, Engine: Replica Motor Company
Posts: 195
Not Ranked     
Default

As indicated previously the MX5 seats(50 cm) are a poor fit in a RMC.
You should get a couple hundred bucks for the seats if advertised on ebay.

These seats are widely used in TR 6's etc.

The two seats that I got are around 42cm wide which is perfect!
The third seat is around 48cm around the cushion which is the limit.

I have been liasing with Marty in the past with the view of getting a pair of seat frames as mentioned in this thread and every time I rang him the seats frames were not certified.

I hope Marty has got his seat frames "rubber stamped" by the young mechanical engineer.
Reply With Quote