Here are the pictures of the completed project.
On the side panels I used the ones supplied as a starting point to make a better fitting pattern for new ones. I used 1/8" Landau closed cell foam with vinyl that matched the seats. I made aluminum clips and glued them with JB Weld to the sides of the body to secure the side panels with trim screws. It had three along the bottom and one up top at the center/side of the footbox.
Larry's modification worked really well by notching the panels for the door and cowl frame bracing so the panels fit right. I screwed a thin piece of aluminum over the frame tubes before gluing on carpet so it was secure and the carpet set flush.
I am glad this is done.
I cut the throttle arm welds and moved it over to center it and added a throttle stop.
This is the Y belt bracket and trim I made to move the belt away from the cowl so it does not rub the paint.
