Quote:
Originally Posted by BAsque1
So you attached the fabricated bracket to the frame of the car not the fiberglass nose right?
|
Nope, I fastened it to the nose with rubber grommets. I had concerns about that, but the weight is very very low while the nose was very rigid. Is it ideal? Nope. I was contemplating a support bracket from far left wall to far right wall this would have also allowed for an
oil cooler to be installed. That said, the width would have to be perfect and since I wasn't fabricating the frame, didn't want to have it come out too short or long in length after going through too much fabrication work. There were some other challenges as well.