Hey Ed, I'm still here. Actually left you a PM yesterday as well -- perhaps you are not setup to receive emails on PM's...?
Been busy with a lot of stuff going on. Also had an incident very recently -- crushed a finger in a hydraulic shear, and it'll be out of commission for quite a while -- just another wrench to the already-hectic phase. I'm very lucky though -- it wasn't too deep in the machine where the actual "blade" is -- just the part that compresses the metal to hold it in place. That was still enough though, cause this particular machine will shear up to 1/2" plate.
So what happened with the Austin meet for April? I got on here real quickly and was a bit confused by which week it was. Did you guys (and gals) meet already for this month?
Hey, I still feel like a real Cobra owner, cause well mine is registered, has been on the street and is much closer to being streetable that some of the other CMC's in this area.
BTW Tony, need your swimming pool cleaned?
Cheers,
-Neil.