Thread: Cobra Valley Ball Joints
View Single Post
  #8 (permalink)  
Old 09-06-2015, 06:32 PM
DanMartin's Avatar
DanMartin DanMartin is offline
CC Member
Visit my Photo Gallery

 
Join Date: May 2011
Location: Hillsboro, OR
Cobra Make, Engine: Superformance Cobra Chassis #408, 427FE, TKO600
Posts: 94
Neutral     
Default
+1 on everything said above.

I opted to buy the tool to remove/install them. Breaker bar...do not use an impact. I had to add a little (not much) heat to get mine to break lose on one side.

When you get the old stockers out you will see how crap they are. The CV stuff is top notch.

Dan
Reply With Quote