I've continued working a few hours a day on the body. the tub is finished to the point that it's ready for final body prep and final finish for pulling molds.
One thing that I didn't like too much on the original Cheetah was the wide radiator opening. I've molded in dividers in my opening. The center opening is the width of the radiator and duct to it. The out side openings are for brake ducts. There will be a small flexible chin spoiler as well.
The picture of the finished car shows what the original style. This car is a Shell Valley. You can clearly see how much faster and lower the bonnet slopes down towards the front.
The last picture shows the rear bulk head for the bonnet. I made it so that the sides are slightly tapered so that it's self centering when lowered. I made the horizontal part of the bulkhead 5/16 inch short of resting on the frame. This allows final height adjustment.
