View Single Post
  #2 (permalink)  
Old 03-15-2018, 11:15 AM
Tom Wells's Avatar
Tom Wells Tom Wells is offline
Senior Club Cobra Member
Visit my Photo Gallery

 
Join Date: Mar 2000
Location: St. Augustine, FL
Cobra Make, Engine: E-M / Power Performance / 521 stroker / Holley HP EFI
Posts: 1,919
Not Ranked     
Default

last,

According to the Edelbrock site here: Intake Manifolds - Ford - Big-Block - Torker II Series - Edelbrock, LLC.

the lowest manifold they make is the Torker II, and it
Quote:
Will fit 429 Cobra-Jets.
Their quoted port size is 1.75" x 2.1". If you decide to use it you can do a port match - I think I recall there's enough material there for doing that.

I use this manifold and its EFI twin on two 385s, each much larger than 460 and they run just fine!

Hope this helps,

Tom
__________________
Wells's law of engine size: If it matters what gear you're in, the engine's too small!
Reply With Quote