Thread: How to build a Griffen radiator mount and what size?
View Single Post
  #3 (permalink)  
Old 05-31-2002, 08:19 PM
renaissance man's Avatar
renaissance man renaissance man is offline
CC Member
Visit my Photo Gallery

 
Join Date: Oct 1999
Location: Georgetown, TX. USA. Little North of, TX
Cobra Make, Engine: SMC Motorcars 289
Posts: 831
Send a message via Yahoo to renaissance man
Not Ranked     
Default
Sorry Bob,

Guess I should have put the basics down. The kit is an "SMC". No longer in biz but identical to a B&B.

What size Griffen do you use Bob? Mine is 22"wide x 19" tall. It looks from the illustrations like your bottom mount is slightly canted to the rear? So, you use no side supports for the radiator? I have some 4" stock billet aluminum that would make a nice support if I could figure out how to secure this bugger. I'm hoping this size radiator will work?

Thanks for helping out. I'll post a pic or two of the current frame if I can get these pics to upload. Got 4 pics (first 4) uploaded when you "view my photo gallery". I labled Upper Front Crossmember's and Radiator Mounts.

Regards,
__________________
Co-founder of the Texas Cobra Club.

Dave "Ren Man"
Last edited by renaissance man; 05-31-2002 at 08:49 PM..
Reply With Quote