Thread: Clutch Master Slave Cylinder Question
View Single Post
  #1 (permalink)  
Old 07-14-2019, 09:56 AM
Jim Coleman's Avatar
Jim Coleman Jim Coleman is offline
CC Member
Visit my Photo Gallery

 
Join Date: Jun 2003
Location: Waco, TX
Cobra Make, Engine: 1980 Arntz, 350 'Vette & Muncie, & Jag rear
Posts: 219
Not Ranked     
Default Clutch Master Slave Cylinder Question
What I need to know is the distance or travel the slave cylinder needs to push open the throw out bearing fork to work correctly.

The car isn't running so I can't start it and see.

The clutch master cylinder is a small Girling; the slave is 7/8" bore.

Chevy 350 with Borg & Beck 3 lever clutch and Muncie 4 speed.


Thanks,

Jim
Last edited by Jim Coleman; 07-16-2019 at 11:50 PM..
Reply With Quote