Thread: Rear braced roll bar
View Single Post
  #21 (permalink)  
Old 09-10-2020, 06:53 PM
mjhcobra's Avatar
mjhcobra mjhcobra is offline
CC Member
Visit my Photo Gallery

 
Join Date: Aug 2003
Location: Tucson, AZ
Cobra Make, Engine: Everett Morrison, 428
Posts: 164
Not Ranked     
Default
Hi Sydney,

I came across this thread and I too am looking for a cross bar to fit my Everett Morrison SS roll bar to attach my harness to. My roll bar is made of 1.25" SS tubing with an OD of 1.66" or 1 5/8". Did you say that your cross bar had 2" ID clamps and that the difference is made up with a rubber pad?
I have been trying to determine which clamps would actually fit my roll bar - and you may have solved my question.
Do you still have a cross bar for sale with the 2" clamps?

Martin
Reply With Quote