View Single Post
  #11 (permalink)  
Old 01-21-2022, 03:37 PM
mrmustang's Avatar
mrmustang mrmustang is offline
CC Member/Contributor
Visit my Photo Gallery
Gold Star Contributor
 
Join Date: Feb 2000
Location: Greenville, SC
Cobra Make, Engine: 70 Shelby convertible, ERA-FIA, 66 mustang convertible, mystery Ford powered 2dr convertible
Posts: 12,614
Not Ranked     
Default

Quote:
Originally Posted by 2020 GT500 CFTP View Post
Awesome tidbits!! Body is primered and on the frame bird cage support system. Doors, hood, trunk lid bonded to 7/8'' tube frames and installed on the car. Foot boes installed as well. 4" very nice copy of the original 427 frame. All suspension pickups in place. It is said to have original style upper/lower control arms, spindles knock off hubs and wing nuts, rotors and all hardware. steering rack assy and tie rods. Aladan coil overs and shocks. Rear, original style upper/lower control arms, drag link, cast iron uprights with pin drive hubs, bearings, drive plates and hardware. 9' ford in a custom HT housing that accepts splined HT half shafts. Trigo wheel 7.5x15 and 9.5 rear pin drive wheels and wing nuts. he says it has cobra windshield frame and support posts, steering column and mounting hardware, gas pedal, pedal box with internal hardware and master cylinders, seat frames, rubber diaphragm seat bottoms. Registered in AZ Rolling chassis. $36.5 OBO. High or good price?
Is it rolling, a fair price
Does it have a MCO (Manufacturers certificate of origin) that can be transferred? This being the most important.

Finally, perhaps a stand alone thread of your own is best.

Bill S.
__________________
Instead of being part of the problem, be part of a successful solution.

First time Cobra buyers-READ THIS
Reply With Quote