[ronzara]

This is a Stewart Warner (From the Cobra Set) Fuel Gauge:

I have the 134 wire attached to the "S" on the back of the gauge And it runs to Sender lug on the tank. I have the 130 wire attached to the "I" on the back of the gauge, and the 190 to the "G".
Gauges Pegs on the FULL side.
If I reverse the the "S" and "I" wires, it pegs on the EMPTY side.

There is about 3-4 gallons of gas in the tank.

130 is showing 12v with key ON.
when I put the meter on the "I" lug (POS) and touch the "S" lug with the NEG I show 12v.

with the key on, at the tank, I touched the POS pole to the Sender lug, and the NEG to a ground, and get 0 reading.


Any Idea's or suggestions?



Also, What do I need to attach to make the Alternator Charge the Battery?
I have all the CR Engine wiring connected but have seen nothing for this. ???


I have connected my horns to the proper wires, but when I press the Horn button on the wheel, I can hear the relay clicking, but NO HORN. ???