[cobra427mnsi]

What do you think of putting the PCV valve directly into the intake manifold? I remember seeing pic of a setup where someone had drilled and tapped a hole in the cast-in boss on the back of the Edelbrock intake (see boss in attached pic). He had a screw in type PCV valve in the hole. From there, it was vented into the rear of the carb. He had two filter type breathers (one on each valve cover) for air intake into the crankcase. It was a very neat and clean looking setup.

I am just putting together a 427 CO and am toying with this idea.

Any suggestions?

Paul