[Tinker51]

This is what I have always been told. The spinner tools are not necessary but if you have one it should not be used for puting the spinner on. If you decide to not use the tool for removal make sure when you are hitting the ears that you keep rotating the ear you are hitting. Do not keep hitting the same ear. When removing the spinners use a lead or dead blow hammer. When installing the spinner snug it up by hand then start tapping the ears with a dead blow hammer, stop when the spinner stops moving. As stated before it does not take a ton of torque. Leave a little slack in the safety wire so you can easily see if the spinner has moved.