Not Ranked
Valve Cover Installation
I am about to install my (awesome Blue Thunder) valve covers and noticed a potential issue. The seam where the manifold and the heads come together is not flush on the valve cover gasket surface. The manifold side is about 1/16-1/8 inch higher. I assume the correct thing to do here is to use some RTV silicone sealer to fill this gap. Any comments? Is this common?
__________________
"There are 10 types of people out there....the ones that understand binary and the zeros that don't."
Last edited by joea; 01-11-2004 at 11:36 PM..
|