[RICK LAKE]

Cracker Have you looked into using hydro lifters with hollow pushrods with these rockers? I don't have my ersons yet but have adjustable iron rockers with this setup in my motor and no problem. I am limited the RPM to 6K chip in the MSD 6AL. I also have a small cam, 501-533. Car runs smooth with a 4 degree retard. Plenty of tork. Runs 12.50 in the 1/4 mile. Small block lifter are the same width but .300 long then solids. Would have to get special push rods from Smith brothers. They cost 150.00$ just my 2 cents. Rick Lake