I'm going to begin building/ordering parts for my aluminum 427 Shelby block tomorrow and would appreciate some feedback before I start putting in my orders. Just an FYI, this cars primary use will be daily-driver/show/and some strip use. I am somewhat undecided as too the manufacturers of a few of the items, hence the ?( )? and am open to any suggestions and/or other possibilities towards the others if you see a problem anywhere in my setup. Here is a current list of what we've already got in mind....
-Shelby 427FE block bored and stroked to a 490ci
-Billet Rods (Oliver)
-Heads Stg 3 (Edelbrock)
-Pistons (CP)
-Crank "cast" ?(Eagle or Scat)?
-Rocker Assembly "roller" (Erson)
-Intake "victor" (Edelbrock)
-Cam "custom" (Lunati)
-Distributor ?(MSD)?
-Wires (Taylor)
-Carb "850cf" (Devincy)
-Water-pump (Edelbrock)
-Bolt Kit (ARP)
-Clutch (McLeod)
-Aluminum Flywheel ?( )?
-Bell housing ?( )?
-Slave Cylinder ?( )?
-Starter ?( )?
and last but not least...
-Tremek 600 or 600rr
Thanks for all your help!
