Thread: Bellhousing Alignment
View Single Post
  #1 (permalink)  
Old 06-19-2004, 08:10 PM
joea's Avatar
joea joea is offline
CC Member
Visit my Photo Gallery

 
Join Date: Sep 2002
Location: Oceanside, CA
Cobra Make, Engine: ERA #676, 428SCJ (2x4), TKOII
Posts: 642
Not Ranked     
Default Bellhousing Alignment
How do I remove the existing alignment dowel pins in my FE block? Seems my top-right pin is in too deep and I barely get contact through the bellhousing? I tried pulling with visegrips without any luck.

After 2 measurements looks like I'm in the area of .017 out of line...so I will need to use the offset dowels.

What a miserable day this has been. Those of you who have gone through this process can comiserate!
__________________




"There are 10 types of people out there....the ones that understand binary and the zeros that don't."
Reply With Quote