Thread: TKO Clutch fork
View Single Post
  #3 (permalink)  
Old 07-29-2004, 08:01 AM
joea's Avatar
joea joea is offline
CC Member
Visit my Photo Gallery

 
Join Date: Sep 2002
Location: Oceanside, CA
Cobra Make, Engine: ERA #676, 428SCJ (2x4), TKOII
Posts: 642
Not Ranked     
Default

I spoke to Doug about it this morning. I did not trim the fork because the end was less 2" wide as described in the manual. I can still do it if necessary but I think the fork will just want to move higher if I do. I an going to try to shim the bracket to get better alignment of the slave cylinder first. The rod threads grinding against the cylinder wall is a bigger issue than the fork rubbing the fiberglass.
__________________




"There are 10 types of people out there....the ones that understand binary and the zeros that don't."
Reply With Quote