Ok, I have a question about cylinder honing. I'm building the engine and it's my first, 302, see my post from yesterday. Anyway, there's some light rust on the cylinder walls. It's more than surface rust since you can feel it with your fingernail and finger tips. Anyway, I have an I.D. guage and need to get this rust out to get a good measurement to know what pistons to order and also to see see how far the rust goes into the cylinder wall. Will light honing myself take care of this? Should I use
oil or do it dry? I of course don't want a fininshed hone job, just want to get this rust off. Thanks!