Thread: Trans/Pinion Angle
View Single Post
  #1 (permalink)  
Old 05-31-2005, 06:57 AM
Haz331 Haz331 is offline
CC Member
Visit my Photo Gallery

 
Join Date: Jan 2004
Location: Georgetown, DE
Cobra Make, Engine: A&C- 351w 5spd
Posts: 61
Not Ranked     
Default Trans/Pinion Angle
Looking for some advise. I installed my motor and trans yesterday and noticed that the tail shaft of my trans is about 3 inches higher than the pinion in the rear. I have the std. rear link arms (non-adj.), so I guess it would be kind of hard to change the pinion angle, if I have to. Would my current driveshaft be too severe? Any suggestions or opions? Thanks, Jerry
Reply With Quote