Thread: Master Cylinder Upgrade?
View Single Post
  #16 (permalink)  
Old 06-16-2005, 12:36 PM
flipper35's Avatar
flipper35 flipper35 is offline
CC Member
Visit my Photo Gallery

 
Join Date: Jul 2001
Location: Southwest, WI
Cobra Make, Engine: Shell Valley, Mopar thingy (small block of course)
Posts: 2,215
Not Ranked     
Default
I had to measure everything and ended up with 1" for the front and 1 1/8th" for the rear, but they are drums in the rear. Pedal is firm, but not as bad as the little MII rotors and 7/8ths" bore Girling.

If I had not asked knowledgeable people I would be using the same 7/8ths bore front and rear. Since I was borderline though, I may move the 1" to the rear and go 7/8ths" on the front. Might have a little too much travel though.
__________________
Brent Dolphin
Reply With Quote