06-27-2005, 01:51 PM
|
|
CC Member
|
|
|
Join Date: May 2001
Location: Irvine, CA.,
CA
Cobra Make, Engine: Classic Roadster 427SC, 351W bored .30, Edelbrock Performer RPM Package, Tremec trans, Currie 9" rear end.
Posts: 50
|
|
Not Ranked
Copper gaskets
Is anybody interested in Copper gaskets? I was having the same problems and went through several paper/wire mesh gaskets and tried the silicon approach as well. After loosing a side pipe on the freeway (don't use grade 8 bolts, they get brittle when hot) I decided to make my own copper gaskets. They are cut out on a computerized router and look too good to install. They are working great. I have a couple sets for the classic Roadster and could probably make any other pattern if there is an interest. I will be bringing them to SAAC 30.
|