Hello,
Could anyone give me some measurements of the 8.8" differential, half shafts and CV joints?
1. Diff. width
2. Diff height
3. Diff length
4. Mount locations relative rear cover
5. Pinion location relative to vertical center line
6. Output location in x & y planes relative to rear cover mnt flange and bottom of diff.
7. Inner CV length and diameter
8. Outer CV length
Is the aluminum housing the same shape as the cast iron one? I'll be using Alum.
I know this is asking a lot, but it would help a lot in my chassis design process. Larry had tried to send this info but it got lost when the site went down.
Thanks very much,
Al Keller
al_keller@earthlink.net