Thread: Progress Photos 427 Chassis
View Single Post
  #11 (permalink)  
Old 04-03-2006, 10:36 AM
KarlCSX2498's Avatar
KarlCSX2498 KarlCSX2498 is offline
Senior Club Cobra Member
Visit my Photo Gallery

 
Join Date: Aug 2004
Location: Near Phila. (Collegeville), PA
Cobra Make, Engine: CSX2498 has been in our family garage since '68....Scratch built aluminum bodied 427SC Cobra, 427FE, CSX3000 chassis specs, 95% finished, only needs paint.
Posts: 642
Not Ranked     
Default 427 Chassis
Hey Jay, the main tubes are 4" DOM .120 tubing. On the front suspension everything was right on except for the height of the shock tower, it was approx. 5/16" high. The cowl hoop and rear hood support that holds the firewall up are very close to the prints. I'm a little off but I will not find out how bad it is until I set the body on. Regards, Karl

John, PM sent back to you.
Reply With Quote