[jerry w]

Ok, here are my measurements:

Top of the roll bar to the body is 13 ½ inches. I am six foot one. I have seen roll bars higher and much lower. Unless you have historical reproduction as your goal the height will be a personal preference.

Tube is 1 ¾ inch (4.5 cm?) I am trying with the metric here. This seems to be an odd size for grommets to cover the hole in the body. I ended up making my own from aluminum. You can see a pic in the thread I started when I was installing my roll bar.

Center to center of vertical bars is 12 ½ inches (35 cm)

The angle is about 70 degrees for center post, but this is not accurate.

Plan where you want to attach the roll bar to the frame and adjust your measurements. The brackets that adjust to the roll bar dimensions and fit/attach to the frame are flat plates with pipe welded on, there is a threaded hole in the pipe for a set/locking bolt to hold the roll bars in the brackets. Sorry I have no pics of the brackets.

My tranny is down, all locked up, can't even get it in neutral. I am scrambling to get it repaired before I miss the little bit of good weather we are affforded here in Upstate New York.

Glad to hear you are making progress.