Fred, I used a standard mount and then I had to make a new cross member with recessed bolt pockets to get the mount to even up with the cross member.
I also had to make a new slave assembly. Thank the lord I have a lathe. I had to spin two of them up as the first one, about 1/2 inch longer than the original, was too short. Anyhow, my wife tried the clutch and she likes this one much more than the old race clutch. I'm getting a little over 5/8 inch of travel.
Don't get flu shots, they just give me the flu...what's the point.
I wish I could send all this rain to someone. It is getting old. I think my pond will be filled with ice this year.
Well, I have three more tasks to finish the installation; shift handle ( I'll forge a new one ), Speedo hookup ( not sure about this one ) and a drive shaft.
I think I am going to make a fire, it is that chilly here.
