Other than having to goose the car to get it really moving off idle, I like the cam around town. Most of my driving is through a couple stop lights and then down into our metroparks where the speed limit is 30mph - I run it at 35mph in 4th gear and it just tools along. Sounds boring, but the route is just a really nice run. After about 45 minutes I'm out on the rural roads where you can run 55 to 80mph up some nice hills, dips and curves - lot'sa fun.
I have a 4 sp top loader from David Kee and (as I recall) a 3:55 rear end.
Here is the parts listing, unfortunately I don't see the valve springs in the list...
Part Number Manufacturer Description
15513 Crower Hydraulic camshaft Ford 302 H.O. 228HR234
M-68HV Melling
Oil pump
M-6500-R302 Ford Hydraulic tappet
15-611 (2026) Canton Small block Ford pickup for 8” deep pan
15-610 Canton Small block Ford 8” deep pan w/stiffener rails
85833 MSD Ford distributor steel gear
M-6605-A302 Ford
Oil pump shaft
J100F8-4030-5 J-E S.R.P. Piston ring
100-7107 ARP Rocker stud kit
- MISC - Clevite Bearings
1332-16 Comp Cams Full roller rocker arms
TFS-51500700 Trick Flow Main support w/ARP main cap bolts
140689 J-E S.R.P Pistons
92727501551S Pins
927042CS Locks
RA4030 Rails
Ferrea Valves
430234005400 Eagle ESP 4340 Crankshaft, forged