Thread: Drive shaft question
View Single Post
  #1 (permalink)  
Old 11-13-2006, 12:34 AM
Automan Automan is offline
CC Member
Visit my Photo Gallery

 
Join Date: Sep 2006
Cobra Make, Engine:
Posts: 242
Not Ranked     
Default Drive shaft question
Hi Everyone: I am about to go to the suspension company and order my driveshaft. Now the yoke at the end of the transmission (Toploader). How far out should i position the yoke to get my measurement. I understand that it can't sit all the way in because of bumps on the road would cause some unwanted attention. Is 1.5 inches too much? Whats your advice?


Thankyou in advance
Automan
Reply With Quote