View Single Post
  #5 (permalink)  
Old 02-28-2007, 11:54 AM
blykins blykins is offline
CC Member
Visit my Photo Gallery

 
Join Date: Dec 2001
Location: Louisville, KY
Cobra Make, Engine: I'm Cobra-less!
Posts: 9,035
Send a message via AIM to blykins
Not Ranked     
Default

I haven't had to yet, but my last build was a 428, so I had plenty of room to spare. I accounted for the lower cc's in my compression ratio calculations.

I just saw you're working with a 427. I don't know if this gasket would work for that large of a bore. If you're .020" over, you'd be right there. I don't know how safe that would be.
Reply With Quote