Thread: Rotors with curved vents, directional?
View Single Post
  #2 (permalink)  
Old 08-15-2007, 01:07 PM
Jac Mac's Avatar
Jac Mac Jac Mac is offline
CC Member
Visit my Photo Gallery

 
Join Date: Feb 2006
Location: Gore. New Zealand., SI
Cobra Make, Engine: DIY Coupe, F/T ,MkIV.
Posts: 808
Not Ranked     
Smile
Vanes pull the air from rotor center to OD, therefore OD of vanes should trail with respect to rotation. Grooves in face of rotor if correct should be machined to 'cross' vanes to avoid stress points, if they are machined parallel to vanes it can create a weak area.

Jac Mac
Reply With Quote