09-04-2007, 12:23 AM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Sep 2002
Location: Montgomery,
TX
Cobra Make, Engine: CR 427 S/C, 351W, 5 Sp & KMP142 - 427 SO, 4 Spd
Posts: 2,212
|
|
Not Ranked
I don't know much about specs for air flow but I'm sure if you need one
that pushes a lot you will need 220v to run it - make sure you have that.
Worst case scenario is change the plug on one to fit your dryer outlet (if it is 220v electric and not gas). I have done this with arc welders with no problems.
__________________
Flip
|