[Venamm]

Hi folks,
I'm late on to this thread but I found it by a word search.

I have a few tube benders plus a whole bunch of various dies in my factory. What I don't have and require is a drawing or template to pop one off. Can anyone provide me with what I need? I am keen to the 14" c2c 1.75 seamless tube. I do notice 2 versions though. One that is a tall upright and sits a clean 90 degrees. It looks so tall that a average basketball players head sitting down wouldn't even be close. It looks wacky to me. The one I've seen and like is a lower version with a bit of a lean back, but tall enough to protect. Not sure if these versions have actual names.
I would like to build one....who knows if easy enough I'll build a shhit load.