Thread: Converting Close Ratio to Wide Ratio
View Single Post
  #1 (permalink)  
Old 03-03-2008, 08:42 PM
ERA174's Avatar
ERA174 ERA174 is offline
CC Member
Visit my Photo Gallery

 
Join Date: Jun 2007
Location: Caldwell, NJ
Cobra Make, Engine: ERA 427, 482ci sideoiler
Posts: 145
Not Ranked     
Default Converting Close Ratio to Wide Ratio
I have a big input/output shaft toploader in my ERA Cobra with 428cj FE. I am considering going wide ratio T/L. My question is what would be less expensive converting a close ratio big in/out to wide ratio big in/out or a wide ratio small in/out to wide ratio big in/out shafts? Assume no other expense(cost to acquire T/L or refurbish worn parts), only the cost of converting to wide ratio big in/out shaft T/L.
Thanks, John
Reply With Quote