[PNJSNAK]

John:
I went with A & C for a lot of stuff. Parts I did not were, steering column, radiator, driveshaft, motor, trans, tires, wheels, accessories.
I was not aware of this and other threads like this. I basically did not know any better.
I had them do the rolling chassis, disk rotors all around.
Pete of Fasttimesrods did the fab work for A & C then.
Pete did the rolling chassis, I had him paint the frame and picked it up from his original shop.
I have had Pete fab a lot of parts for me after that.
Pete gets the bodies from A & C and everything else he does is his work. He has made changes to the A & C chassis and fabs the chassis in his shop as well as a lot of components.
He also is a distributor for just about all the parts you will need for your build.
I have no regrets going with A & C, Joe was always very helpful in my build.
If it were me doing it again I would have to go with Pete at Fasttimesrods now with what I have learned and know.

This site and the guys on it like Roscoe are a great help and always eager to help out or voice an opinion.

Great choice with the A & C body, the gelcoat has been great.
Seven years on the road and 13k miles, still looks great.

Good luck with your build.

Jim