Not Ranked
Here is a schematic that came with the wiper switch from Finish Line. Just remember that the top post that is perpendicular to the other four is negative and you can easily figure out the rest of the wires. I used a standard 2 way switch (without a park) rather than the one from Finish Line because the one from finish line was about 14mm rather than ˝ inch and did not want to risk enlarging the hole in the finished padded dash. With the two way switch it takes a couple of tries to get the windshield wipers parked in the proper position but the car has never been caught in a rain so it probably doesn’t matter much. Before I put the either switch in, I “bench wired” the wiper motor with both switches. Both worked fine.
It is pretty straight forward. If this is not enough, let me know. Rick
|