Thread: AN sizing
View Single Post
  #6 (permalink)  
Old 07-05-2008, 08:39 AM
speed220mph's Avatar
speed220mph speed220mph is offline
CC Member
Visit my Photo Gallery

 
Join Date: Sep 2002
Location: Hickory, NC
Cobra Make, Engine: ERA 427SC w/427so, ERA GT #2002
Posts: 1,106
Not Ranked     
Default
BMK
I have a chart on page 141 in my book, "Racing Engine Builder's Handbook". If you don't have a copy of this great book following are some specifics. As was said, the dash number is pipe size in 1/16". ID for -10 and -12 AN hose is 9/16" and 11/16", respectively. I think Carroll Smith covered this subject in depth in his book on Racing Hardware.

Check out this sight for loads of good stuff from coolers, to AN fittings to Fuel filler caps. http://www.batinc.net/mocal.htm

Specific to your question, check out this page: http://64.202.180.37/files/tchart.pdf
__________________
Tom

"If you can make black marks on a straight from the time you turn out of a corner until the braking point of the next turn, then you have enough HORSEPOWER." Mark Donohue
Last edited by speed220mph; 07-09-2008 at 06:45 AM..
Reply With Quote