I have been given the opurtunity to by the Jigs for the small block headers. Unfortunately I will have to buy a new set of dies to fit the bender which will cost me almost $500.00 for the smaller tubes. If there are enough people that still need them I will make the investment. The cost will be 10% higher than what Don was charging strictly because of the cost of the steel.
On the tops I may be able to buy 4 black tops and one tan/brn top too. However these will not have the windows at this time. I think I can get the tops, I just need to know if there is enough interest on the headers.
The side pipes will come later. I promise these will not be the restrictive type giveing small blocks at least 20 real HP to the rear wheels and the BB's as much as 45 additional ponies, with a much deeper sound and not so many decibels!. (These numbers have been verified per professional Dyno's.).
Time to get in or out of the bathroom people, once they are gone they are all gone!
DV
I'm trying to help but I wont/can't stick my neck out to far!