Not Ranked
What works best for me is to take that cup checker and trim the cup portion down until it's essentially flat - just a locating divot left in the center. Measure your desired length not forgetting lash - and order your pushrods specifying the length to "bottom of cup". Your pushrods will come in marked as "BOC" next to the length. Easy.
__________________
Survival Motorsports
"I can do that....."
Engine Masters Challenge Entries
91 octane - single 4bbl - mufflers
2008 - 429 cid FE HR - 675HP
2007 - 429 cid FE MR - 659HP
2006 - 434 cid FE MR - 678HP
2005 - 505 cid FE MR - 752HP
|