10-30-2001, 06:33 AM
|
 |
CC Member
|
|
|
Join Date: Nov 1999
Location: White Plains,,
NY
Cobra Make, Engine: ERA140, ERA 267, ERA GT2038, ERA FIA 2045, ERAGT2077 ERA2893000EXP
Posts: 1,117
|
|
Not Ranked
Bob:
You know I'm there for you, buddy.
As you may recall (or not) I had 14" wide wheels on my GT and we ended up machining approx. 0.90" off the back of the wheel. Were I to do it again, I would take a little less off because there was some minor interference with the brake cooling duct in the wheel-well. My recollection (now ten years fuzzy) was that holes for the (6) pin drives were plenty deep enough and did not need to be modified.
Jim Holden
|