Thread: Exhaust Probe for my LM1
View Single Post
  #1 (permalink)  
Old 01-16-2009, 07:15 PM
onefastmustang's Avatar
onefastmustang onefastmustang is offline
CC Member
Visit my Photo Gallery

 
Join Date: Jun 2005
Location: Fairfield, ca
Cobra Make, Engine: CRII with a Stroked Windsor
Posts: 976
Not Ranked     
Default Exhaust Probe for my LM1
I have an LM1 that I have used to try and dial my webers in with. It has the exhaust clamp on it but I personally think that the clamp is not a suitable solution with side pipes for a couple of reasons. One is that the car likes to blow the sensor out of the pipe and two I think it is not accurate because fresh air can get sucked back into it. Has anyone seen an exhaust probe that will accept the O2 sensor or for that matter a design of one I could make?

TIA
Reply With Quote