Thread: "vacuum gauge" to balance stacks?
View Single Post
  #19 (permalink)  
Old 04-29-2009, 10:26 AM
fkemmerer's Avatar
fkemmerer fkemmerer is offline
CC Member
Visit my Photo Gallery

 
Join Date: Nov 2006
Cobra Make, Engine: ERA, FE BBF
Posts: 389
Not Ranked     
Default
Your CAM is pretty close to what I have in my 482 FE (mine is 242/248 @0.050, 112 degree LSA, Lift is .645/.635in). My setup uses speed density mode and idles nicely at about 800 RPM. I was also at the 60% load point in my map at 800 ROM idle. I did use the timming trim feature to help get a smooth idle and my TWM intake has an IAC installed. Do you remember what your VE table setting was at idle in speed-density mode? Mine is at 26. Also, what is your motor's displacement again?

- Fred
Reply With Quote