[D&M2]

Hi Everyone,

I am looking to re-do the wiring harness for the dash. I have gone thru a couple of iterations but am still not satisfied. Thus far I have used serial connections where I have inserted two wires into each connector, one from input source and the other running to the next guage. I have also tried Y connectors which allowed for better connection of the wire for each guage but takes up a lot of room.

I have thought about running individiual power and ground wires for each guage back to a central source. While that would allow me to isolate each connection, I am concerned that the size of the wiring harness may end up being to bulky to route effective thru the dash. Also, for the power, having a central connection point may be difficult to achieve safely.

Any thoughts or ideas on what has worked well for you and allow the finished product to be neat and clean.

Thanks.

Mike