|
Front License Plate Install?
For those of you that have installed the front license plate bracket from Finishline how did you get the lower washer and nut on the threaded rod? There is absolutely no room at all to get the washer and nut on let alone tighten it. I have the overriders on my SPF.
I was thinking the trick is to take off the overrider, secure the license plate bracket, then re-install the completed overrider? Any help is appreciated. Thanks Stu. |
Behind an over rider I did a cut through the top spacer tube to make the bracket vertical and assembled it with the rods and spacer tubes. Top one from the front goes, over rider, short spacer, bracket, long spacer.
|
Thanks mickmate! I'll tackle it again this week end.
Stu. |
| All times are GMT -7. The time now is 02:18 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: