Front License Plate Install?

[Sawdust]

For those of you that have installed the front license plate bracket from Finishline how did you get the lower washer and nut on the threaded rod? There is absolutely no room at all to get the washer and nut on let alone tighten it. I have the overriders on my SPF.

I was thinking the trick is to take off the overrider, secure the license plate bracket, then re-install the completed overrider?

Any help is appreciated.

Thanks
Stu.

[mickmate]

Behind an over rider I did a cut through the top spacer tube to make the bracket vertical and assembled it with the rods and spacer tubes. Top one from the front goes, over rider, short spacer, bracket, long spacer.

[Sawdust]

Thanks mickmate! I'll tackle it again this week end.

Stu.