05-22-2017, 08:39 PM
|
|
CC Member
|
|
|
Join Date: Mar 2009
Location: Mendota,
IL
Cobra Make, Engine:
Posts: 697
|
|
Not Ranked
Ok here is what I am trying to remedy before I get any further along.
Right now I only have 1 front fia wheel from Trigo. Will get another front soon.
In the below picture is a front hub mounted in the front wheel. Thread engagement looks perfect. Spinner is on about 9 1/2 turns.
In this picture a rear hub is mounted in the same wheel. I don't think there is enough thread engagement. It is only about 4 1/4 turns on.
Wheel hub thickness is about 3 7/16. This wheel has the right backspacing is correct for an original car. I was hoping that that a rear Trigo wheel had a thinner hub and get more thread engagement.
In this picture you can see that the rear hubs are shorter than the front ones by about 3/4 of an inch.
Does anyone know how long the hub is from the mounting flange on original cars that fit these wheels?
Last edited by MAStuart; 05-22-2017 at 08:42 PM..
|
9Likes
Threaded Mode
