ALI Lift point guide

TX-Excalibur · #1 (**permalink**) 03-08-2019, 03:38 PM

Has anyone invested in this that they would like to share with me. I have four vehicles ranging from an F150 to the cobra that I would like to get the measurements for the lift points before I anchor the lift into the cement. Appreciate any comments also.

RockBit · #2 (**permalink**) 03-09-2019, 04:04 PM

Quote:

Originally Posted by TX-Excalibur

Appreciate any comments also.

I don’t have an Ali lift. I installed a Maxjax two post lift primarily for my ERA cobra. I set the lift columns as wide as I could and still have the arms, at full extension, reach the frame rails of the ERA (which are 28 inches apart). I figured my other vehicles have lift points that are much wider than the Cobra, so I would have a shot at lifting the other vehicles.

I have not put any other car on the lift yet. It works great on the cobra.

My columns ended up being 120 inches wide. The recommended range by Maxjax was 90 to 130 inches.

TX-Excalibur · #3 (**permalink**) 03-09-2019, 04:17 PM

Thanks for reply. I will be installing a MaxJax also when it arrives this week. The ALI Lift Point guide I was referring to is a 70 page purchase online. I primarily wanted to consult it for the F150 (my heaviest vehicle). I am planning to outfit a couple of cable winches to the rafters as a safety device. I will let you know how I make out with the install.