10-26-2021, 05:39 PM
|
 |
CC Member
|
|
|
Join Date: Feb 2001
Location: BRADENTON,
FL
Cobra Make, Engine: KIRKHAM 427 S/C, SHELBY 427 ALUM. STROKER
Posts: 1,396
|
|
Not Ranked
weber linkage
Greetings fellow weber masochists :
I have the bellcrank centered on the intake with two short rods going to the L & R master carb, a kit from Peirce Manifolds.
When I try to sync the master & slave with the slave rod the adjustment goes fast when I tighten the lock nuts due to accumulated slop in the threads and the cup & ball joints.
Any one have a cure or procedure for this, or know where I might find a better quality linkage ? ( forget Peirce, they only sell what I have )
__________________
"When Injustice becomes Law,
Rebellion becomes Duty." T. Jefferson
|
11Likes
Threaded Mode
