|
I think i might have one of them sitting under the bench in the garage!
Andy. |
Heck!
I'm sure I can set that back far enough to get a "proper" weight ratio! :) DV...of course we might have to extend the wheel base a little! ;) |
The banners on the wall are printed in Korean. I can't believe that anywhere but Korea would have such in a factory.
|
WOOOOOOW!
Thanks for the tour , Fixit KK |
Ring and pinion
And just what do we do for a ring and pinion? Instead of a 3.25 ratio one would need about a 0.05 to get the same top speed at 102 rpm instead of 6000. Thats 20 teeth on the pinioin for each on the ring gear! Or the world's highes ratio O.D. transmission.
Bruce |
Is this...
...one of those marine diesels that "starts" on diesel and then runs on bunker oil when it is warmed up?
I understand they run them on the diesel in port and other areas where there are air quaility controls and switch to the bunker when out past the international line to save cash... Rick:confused: |
We ran ours on "DFM" Diesel fuel Marine. But most commercial outfits run them on heavy oil which has to be heated to around 200 deg F to even be pumped. It can be cut with light oil. The down fall to this oil is it is dirty. You score liners, and clog injectors. Let me tell ya, its not fun cleaning 3ft tall injectors, and if they get scored, forgetaboutit.....its off the the manufacturer as they are all lapped and matched parts!
|
| All times are GMT -7. The time now is 10:01 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: