| luke-44 |
02-11-2004 08:13 PM |
Quote:
Originally posted by Rick Bagley
Luke,
You don't drill holes in the valve covers to install the badges. The nicer badges are from Branda. Cut the pins off with a Dremmel Tool and cut off wheel. Use High Temp. RTV Gasket Sealant/Maker (Permatex), CLEAN both surfaces with alcohol or some other good de-greaser and stick them on. Let the RTV cure for 24 hours and they will be on forever.
|
Rick - thanks - that was exactly the advise I was looking for - funny Branda didn't suggest it. It seemed like such a shame to drill the vc's.
I think I'll put them on without badges and decide how I like the look. |
| All times are GMT -7. The time now is 04:07 AM. |
|
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link:
